People usually pay great attention to the use of new vehicles during the break-in period. They are always concerned that a poor break-in period for the vehicle will affect future performance. At the same time, they want to hurry to make money. Since it is a new machine, if not used strictly, with a warranty period, the result is often that the machine is overloaded, early failures occur frequently, adding a lot of unease. Purchasing a new highway pile driver also significantly reduces the service life of the highway pile driver. Firstly, it is necessary to ensure the workload is appropriate and not to operate overloaded. During the break-in period of the highway pile driver, the workload should not exceed 60% of the additional workload to avoid overheating caused by the highway pile driver working continuously for a long time. Do not start driving the vehicle. Be sure to check the dashboard, engine oil, and sealing performance. When the pile driver road is parked for a long time, smooth oil should be added to the smooth point each shift, the nitrogen in the hydraulic hammer should be drained, and the oil port should not be exposed. Keep the whole machine clean and covered with a plastic cover. After charging, remove the battery and store it in a dry place. When the storage time reaches 6 months, the parts should be rotated without load for 15 minutes, and related parts should be lubricated. Highway pile drivers, due to the rough appearance of parts, this highway has just been put into use. During operation, the high and low parts collide with each other, and the scraped metal debris continues to contribute to the conflict. Therefore, the wear of parts during this period is the simplest. If the current highway pile driver parts are overloaded, it is easy to form damage to the highway pile driver parts, causing early new machine failures.
Please fill out the form below according to your needs, and a Hengwang product specialist will contact you within one day.