What to Do When a Hydraulic Piling Machine Abnormally Heats Up: The hydraulic piling machine is likely familiar to many of you. Its emergence has greatly facilitated the work of outdoor workers, enhancing work efficiency and reducing work hours. However, after long-term operation, the piling hammer of the hydraulic piling machine is particularly prone to overheating. This can lead to damage to other components. Sometimes, abnormal heating may occur shortly after starting work. Therefore, it is necessary to have appropriate strategies for dealing with these issues. Today, I will talk about this.

1. 1.Set the fuel pump of the hydraulic piling machine to neutral, raise the upper piston rod, and perform empty strikes multiple times until the penetration depth of the pile is within the normal range. The pile hammer can start normally. In winter, do not use diesel fuel intended for summer, as this can cause the wax in the diesel to precipitate and block the main oil passage. Remember this point clearly and never use automotive gasoline as a substitute for diesel.

2. 
   

3. 2.Remove the fuel pipe from the fuel pump of the hydraulic piling machine and drain the unnecessary water until diesel is seen flowing out. Then vent the fuel pump, set it to neutral, remove the screws locking the cylinder, raise the landing gear and the upper piston rod, perform empty strikes multiple times to completely drain the water from the cylinder, and then reinstall and lock the screws.

4. 
   

5. 3.In addition to operating the hydraulic piling machine according to the instructions, it's also important to pay attention to regular maintenance. Even if common faults like overheating occur, there's no need to worry. Problems can be resolved by following the aforementioned solutions and performing operational inspections.

6.